11.6 Inch 1920x1080 Lcd All Viewing Angle 30 Pin Edp 220 Nit

General Description:

The manufacturer of M116B30-040-121-0102 is BOE, the product content is TFT LCD Module, the Display size is 11.6 ", the Active area is 256.32(H) × 144.18 (V)mm, The Pixel Format is 1920(H) ×1080(V), the Pixel pitch is 0.1335(H) x 0.1335(V)mm, and the Pixel configuration is R, G, B vertical stripe.

Specifications:

Interface Connection:

CN1 (eDP signals , +3.3V DC power supply and B/L power supply)

[Note]:P: POWER I: Input O: Output

[Note1] Don’t input any signals or any powers into a NC pin. Keep the NC pin open.

[Note2] The shielding case is connected with signal GND.Connector used :20455-030E-76(I-PEX),Corresponding connector : 20453-030T (I-PEX)

Absolute Maximum Ratings:

“Absolute Maximum Ratings” is regulations that do not exceed it even momentarily.

Stress beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device.

[Note1] eDP signals

[Note2]Backlight control signals (BL_ENABLE,BL_PWM_DIM)

Backlight Driving:

The backlight system is an edge-lighting type with white-LED.

(It is usually required to measure under the following condition: Ta=25C±2C)

[Note6-3-1]Vpwm Input : 100%= Max luminance 1%= Min luminance

[Note6-3-2]The minimum value of the dimming signal pulse width is assumed regulations of the width of high and the width of low.

[Note6-3-3]VCNT Input : High = BL turn on, Low or OPEN =BL turn off

VBL-dip conditions

Optical Specification:

The measurement shall be taken 30 minutes after lighting the module at the following rating.

Condition: PWM Duty = 100%

The optical characteristics shall be measured in a dark room or equivalent.

Matters Needing Attention:

1.Be sure to turn off the power supply when inserting or disconnecting the cable.Please insert for too much stress not to join a connector in the case of insertion of a connector.

2.Be sure to design the cabinet so that the module can be installed without any extra stress such as warp or twist.

3.Since the front polarizer is easily damaged, pay attention not to scratch it.

4.Wipe off water drop immediately. Long contact with water may cause discoloration or spots .

Reliability Test Items:

[Result Evaluation Criteria] Under the display quality test condition with normal operation state. Do not change these condition as such changes may affect practical display function.

[Normal operation state] temperature :+ 15~ +35C ,Humidity :45~75% ,Atmospheric pressure :86~106kPa

Shenzhen FRIDA LCD Co., Ltd is a high-tech enterprise specializing in LCD display and touch panel, smart cloud, software, hardware and mold development, is committed to becoming a standard and customized audio and video solution provider in AIOT field for our customers.
FRIDA LCD was founded in 2011, has experiences of 10 years in production and 3 years in solution development, and established a set of scientific, strict quality management system as the lifeline of the enterprise.Products from 0.96-32 inch LCD and touch panel.